Pattern Name:220V Important Notes: 1)-------Please read the Controller Configuration Manual, especially the "Advanced Setting" part, carefully BEFORE making any changes on the controller. 2)-------The controller unit is 100% brand new. But due to manufacturing reasons, stains, dusts or scratches may be present on the silicone case. The case may also fit loosely. Please consider this before the purchase. 3)--------Please heat only when after it's mounted onto the build plate (Aluminum plate recommended). A supporting frame/layer is strongly suggested to have the heating element "sandwiched" tightly for better heating result.
J**R
Best upgrade so far to my CR-10 S4
This has to be the best upgrade so far. Fits perfectly. Heats up faster than the nozzle. 80C in just a few minutes. The only down side is that with the external box when the print finishes it doesn't turn off the bed heater. Trying to fix that with some TP Link plugs. One note though it makes your bed sit higher so had to build an adjustment for my Z axis switch. Basically ended up moving the Z axis limit switch up about 5 mm.Yes it does take a lot of time to get in but once you do and get your printer redialed in you won't regret it. It vastly decreases by print time by virtually wiping out the bed heating time. I can turn on the printer and bed heater and go send a print to octopi and by the time the nozzle gets up to temp the bed is ready to go (saves about 40 minute compare to the old way).Note that while you should unsolder the old bed heater you still need to leave it connected if you don't reflash the firmware so that the temp senor at least gets some reading. Otherwise if you remove it you can't print due to bed min temp warnings. Personally I rehooked the wiring up and heat shrunk each bed heater wire so they can't possibly touch anything. The temp sensor always reads 18C. Unchecked heated bed in both Cura and Octopi.The only down side was the wait for it to arrive. Took one afternoon to install. Mostly due to cleaning old glue and insulation off original bed.
D**1
WOW... I Needed This
Ohhhh Myyyyyyy Gosh. Wow this thing heats up fast O_O I mean, I knew that it would be faster than my stock CR-10 S4 but seriously, this thing gets the top of my bed to 65 degrees C in just a few minutes!! My old heated bed used to take (literally) OVER 45 minutes. It was ridiculous. With this thing, I just kick it on a few minutes before I start the print.Pro tip: On the CR-10 S4, don't try to remove the bed heating element if it's one of the larger ones that's glued on. Just put this OVER the old heating element. Works just fine. Just make sure you remove the wires + soldering from the old bed heater before you apply this one. If you have the screw-on type of stock bed heater, then DO remove that before you put this one on.I'm also going to integrate the control for this into my EZABLE kit, which is apparently doable!
D**E
Best you can buy.
Incredible. 110 degrees in 2 minutes. Transformed my CR-10, and will buy for my other printer.
P**O
excellent
Meet all expectations....
Trustpilot
1 week ago
2 weeks ago
